3Com Wireless LAN WX1200 - Manual (Page 416)

416 C HAPTER 12: STP C OMMANDS
Examples — The following command enables port fast convergence on
ports 2, 5, and 7:
WX1200# set spantree portfast port 2,4,7 enable
success: change accepted.
See Also
„
display spantree portfast on page 402
set spantree portpri Changes the STP priority of a network port or ports for selection as part
of the path to the STP root bridge in the default VLAN on a wireless LAN
switch.
Syntax — set spantree portpri port-list priority value
„
port-list — List of ports. MSS changes the priority on the specified
ports.
„
priority value — Priority value. You can specify a value from 0
(highest priority) through 255 (lowest priority).
Defaults — The default STP priority for all network ports is 128.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command applies only to the default VLAN (VLAN 1). To
change the priority of a port in another VLAN, use the set spantree
portvlanpri command.
Examples — The following command sets the priority of ports 3 and 4 to
48:
WX1200# set spantree portpri 3-4 priority 48
success: change accepted.
See Also
„
clear spantree portpri on page 395
„
clear spantree portvlanpri on page 396
„
display spantree on page 398
„
set spantree portvlanpri on page 418