3Com Wireless LAN WX1200 - Manual (Page 609)

23
S
YSTEM
L
OG
C
OMMANDS
Use the system log commands to record information for monitoring and
troubleshooting. MSS system logs are based on RFC 3164, which defines
the log protocol.
Commands by
Usage This chapter present system log commands alphabetically. Use Table 110
to locate commands in this chapter based on their use.
clear log Clears the log messages stored in the log buffer, or removes the
configuration for a syslog server and stops sending log messages to that
server.
Syntax — clear log [buffer | server ip-addr]
„
buffer — Deletes the log messages stored in nonvolatile storage.
„
server ip-addr — Deletes the configuration for and stops sending
log messages to the syslog server at this IP address. Specify an address
in dotted decimal notation.
Defaults — None.
Table 110 System Log Commands by Usage
Type Command
System Logs set log on page 614
set log mark on page 616
display log config on page 612
display log buffer on page 610
display log trace on page 613
clear log on page 609