3Com Wireless LAN WX1200 - Manual (Page 511)

set dot1x max-req 511
Examples — Type the following command to enable key transmission:
WX4400# set dot1x key-tx enable
success: dot1x key transmission enabled.
See Also
„
display dot1x on page 505
set dot1x max-req Sets the maximum number of times the WX retransmits an EAP request
to a supplicant (client) before ending the authentication session.
Syntax — set dot1x max-req number-of-retransmissions
„
number-of-retransmissions — Specify a value between 0 and 10.
Defaults — The default number of EAP retransmissions is 2.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To support SSIDs that have both 802.1X and static WEP clients,
MSS sends a maximum of two ID requests, even if this parameter is set to
a higher value. Setting the parameter to a higher value does affect all
other types of EAP messages.
Examples — Type the following command to set the maximum number
of EAP request retransmissions to three attempts:
WX4400# set dot1x max-req 3
success: dot1x max request set to 3.
See Also
„
clear dot1x max-req on page 501
„
display dot1x on page 505