3Com Wireless LAN WX1200 - Manual (Page 319)

display radio-profile 319
Long Retry Limit Number of times a radio in the radio profile can send a long
unicast frame without receiving an acknowledgment. A long
unicast frame is a frame that is equal to or longer than the
RTS threshold.
Long Preamble Indicates whether an 802.11b radio that uses this radio
profile advertises support for frames with long preambles
only:
„
YES — Advertises support for long preambles only.
„
NO — Advertises support for long and short preambles.
Allow 802.11g
clients only Indicates whether the 802.11b/g radios in the radio profile
restrict associations to 802.11g clients only:
„
No — 802.11b/g radios allow associations with both
802.11b and 802.11g clients.
„
No — 802.11b/g radios allow associations with 802.11g
clients only.
Note: This field applies only to 802.11b/g radios.
Tune Channel Indicates whether RF Auto-Tuning is enabled for dynamically
setting and tuning channels.
Tune Power Indicates whether RF Auto-Tuning is enabled for dynamically
setting and tuning power levels.
Tune Channel
Interval Interval, in seconds, at which RF Auto-Tuning decides
whether to change the channels on radios in a radio profile.
At the end of each interval, MSS processes the results of the
RF scans performed during the previous interval, and
changes radio channels if needed.
Tune Power Interval Interval, in seconds, at which RF Auto-Tuning decides
whether to change the power level on radios in a radio
profile. At the end of each interval, MSS processes the results
of the RF scans performed during the previous interval, and
changes radio power levels if needed.
Power Backoff Timer Interval, in minutes, at which radios in a radio profile reduce
power after temporarily increasing the power to maintain
the minimum data rate for an associated client. At the end of
each power-backoff interval, radios that temporarily
increased their power reduce it by 1 dBm. The power
backoff continues in 1 dBm increments after each interval
until the power returns to expected setting.
Channel Holddown Minimum number of seconds a radio in a radio profile must
remain at its current channel assignment before
RF Auto-Tuning can change the channel.
Table 63 Output for display radio-profile (continued)
Field Description