3Com Wireless LAN WX1200 - Manual (Page 342)

342 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
„
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„
mode enable — Enables a radio.
„
mode disable — Disables a radio.
Defaults — MAP access point radios are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile.
Usage — To enable or disable one or more radios to which a profile is
assigned, use the set ap radio radio-profile command. To enable or
disable all radios that use a specific radio profile, use the set
radio-profile command.
Examples — The following command enables radio 1 on the MAP access
points connected to ports 1 through 5:
WX1200# set ap 1-5 radio 1 mode enable
success: change accepted.
The following command enables radio 2 on ports 1 through 3:
WX1200# set ap 1-3 radio 2 mode enable
success: change accepted.
See Also
„
clear {ap | dap} radio on page 286
„
display {ap | dap} config on page 290
„
set {ap | dap} radio radio-profile on page 343
„
set radio-profile mode on page 362