3Com Wireless LAN WX1200 - Manual (Page 186)

186 C HAPTER 7: IP S ERVICES C OMMANDS
„
set snmp protocol on page 186
„
set snmp security on page 187
„
set snmp usm on page 188
„
display snmp notify target on page 152
set snmp protocol Enables an SNMP protocol. MSS supports SNMPv1, SNMPv2c, and
SNMPv3.
Syntax — set snmp protocol {v1 | v2c | usm | all} {enable | disable}
„
v1 — SNMPv1
„
V2c — SNMPv2c
„
usm — SNMPv3 (with the user security model)
„
all — Enables all supported versions of SNMP.
„
enable — Enables the specified SNMP version(s).
„
disable — Disables the specified SNMP version(s).
Defaults — All SNMP versions are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — SNMP requires the switch’s system IP address to be set. SNMP
will not work without the system IP address.
You also must enable the SNMP service using the set ip snmp server
command.
Examples — The following command enables all SNMP versions:
WX1200# set snmp protocol all enable
success: change accepted.
See Also
„
set ip snmp server on page 169
„
set snmp community on page 175