3Com Wireless LAN WX1200 - Manual (Page 181)

set snmp notify target 181
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectSpoofedMacAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectSpoofedSsidAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedOuiTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedSsidTraps
success: change accepted.
See Also
„
clear snmp notify profile on page 133
„
set ip snmp server on page 169
„
set snmp community on page 175
„
set snmp notify target on page 181
„
set snmp protocol on page 186
„
set snmp security on page 187
„
set snmp usm on page 188
„
set snmp notify profile on page 177
set snmp notify
target Configures a notification target for notifications from SNMP.
A notification target is a remote device to which MSS sends SNMP
notifications. You can configure the MSS SNMP engine to send
confirmed notifications (informs) or unconfirmed notifications (traps).
Some of the command options differ depending on the SNMP version
and the type of notification you specify. You can configure up to 10
notification targets.
SNMPv3 with Informs To configure a notification target for informs from SNMPv3, use the
following command: