3Com Wireless LAN WX1200 User Manual
Page 579
load config
579
If you do not specify a filename, MSS uses the same configuration
filename that was used for the previous configuration load. For example,
if the WX switch used configuration for the most recent configuration
load, MSS uses configuration again unless you specify a different
filename. To display the filename of the configuration file MSS loaded
during the last reboot, use the display boot command.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command completely replaces the running configuration
with the configuration in the file.
Examples — The following command reloads the configuration from the
most recently loaded configuration file:
WX4400# load config
Reloading configuration may result in lost of connectivity,
do you wish to continue? (y/n) [n]y
success: Configuration reloaded
The following command loads configuration file testconfig1:
WX4400# load config testconfig1
Reloading configuration may result in lost of connectivity,
do you wish to continue? (y/n) [n]y
success: Configuration reloaded
See Also