3Com Wireless LAN WX1200 - Manual (Page 367)

set radio-profile service-profile 367
auth-fallthru web-auth Uses WebAAA for users who do not
match an 802.1X or MAC authentication
rule for the SSID requested by the user.
auth-psk disable Does not support using a preshared key
(PSK) to authenticate WPA clients.
beacon enable Sends beacons to advertise the SSID
managed by the service profile.
cipher-ccmp disable Does not use Counter with Cipher Block
Chaining Message Authentication Code
Protocol (CCMP) to encrypt traffic sent to
WPA clients.
cipher-tkip enable When the WPA IE is enabled, uses
Temporal Key Integrity Protocol (TKIP) to
encrypt traffic sent to WPA clients.
cipher-wep104 disable Does not use Wired Equivalent Privacy
(WEP) with 104-bit keys to encrypt traffic
sent to WPA clients.
cipher-wep40 disable Does not use WEP with 40-bit keys to
encrypt traffic sent to WPA clients.
psk-phrase No passphrase
defined Uses dynamically generated keys rather
than statically configured keys to
authenticate WPA clients.
psk-raw No preshared
key defined Uses dynamically generated keys rather
than statically configured keys to
authenticate WPA clients.
rsn-ie disable Does not use the RSN IE in transmitted
frames.
shared-key-auth disable Does not use shared-key authentication.
This parameter does not enable PSK
authentication for WPA. To enable PSK
encryption for WPA, use the
set radio-profile auth-psk command.
ssid-name private Uses the SSID name private.
ssid-type crypto Encrypts wireless traffic for the SSID.
tkip-mc-time 60000 Uses Michael countermeasures for 60,000
ms (60 seconds) following detection of a
second MIC failure within 60 seconds.
Table 67 Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set
to Default Value