HP XP Racks - Manual (Page 50)

Table 10 Business Continuity Manager identification of storage system models and serial numbers
What is considered to be a storage system
serial number What is considered
to be a storage
system Storage system model
Physical DKC serial number Storage system XP12000/XP10000 disk array
Physical DKC Serial number. While the
capability of a logical DKC is in the Logical DKC HP XP7 storage or XP24000/XP20000,
XP P9500 disk array
design of the product, only LDKC 0 is
implemented from the perspective of the
end user in a mainframe environment.
Setting up Business Continuity Manager
After Business Continuity Manager is installed and configured for each data center in the
configuration, you must perform some initial setup tasks. For more information about these tasks,
see
“Preparing to use Business Continuity Manager” (page 118)
NOTE: Some of these tasks must be performed for each site in the configuration. For detailed
information, see “Configuration definitions” (page 144) .
Each of the following tasks can be selected from an item on the Main Menu ISPF panel.
•
Scan each site to acquire information about the volumes; transfer this information to the primary
site. See
“Acquiring volume information” (page 583) .
•
Define and establish a set of inter-control unit logical paths or inter-disk controller logical paths.
See
“Creating a path set” (page 591) .
•
Define the route list. See “Defining a route list” (page 606) .
•
Register a command device in a storage system. See “Setting up Storage Systems” (page 119) .
•
Define a copy group. See “Defining a copy group” (page 641) .
50 Overview of HP XP7 for Business Continuity Manager