HP Onboard Administrator - Manual (Page 10)

Introduction 10
2 If redundant Onboard Administrator firmware versions do not match, the settings are not automatically synchronized.
Synchronize the firmware by using the Insight Display, GUI, or CLI command, and then the settings are automatically
synchronized to the replaced Onboard Administrator module.
Access requirements
To access HP BladeSystem Onboard Administrator web interface, you must have the Onboard Administrator
IP address and a compatible web browser. You must access the application through HTTPS (HTTP packets
exchanged over an SSL/TLS-encrypted session).
HP BladeSystem Onboard Administrator web interface requires an XSLT-enabled browser with support for
JavaScript 1.3 or the equivalent.
For a list of browsers supported for use with Onboard Administrator, see the latest version of the Onboard
Administrator release notes.
Before running the web browser, you must enable the following browser settings:
• ActiveX (for Microsoft® Internet Explorer)
• Cookies
• JavaScript
If you receive a notice that your browser does not have the required functionality, be sure that your browser
settings meet the preceding requirements, and see "Recovering the administrator password (on page
19 )."
If you use an installed language pack with the Onboard Administrator GUI and the browser does not display
all characters correctly, make sure the operating system has the corresponding language support installed.
To access HP BladeSystem Onboard Administrator CLI, use HP BladeSystem Onboard Administrator IP
address and a terminal or terminal application. To access the CLI interface, you must use Telnet or SSH,
depending on which of these protocols are enabled.
The following ports are used to access and monitor the Onboard Administrator.
Protocol Incoming port Outgoing port
SSH 22 —
Telnet 23 —
SMTP — 25
Browser access 80 80
Browser access encrypted 443 443
SNMP get/set 161 —
SNMP traps — 162
LDAP SSL — 636
LDAP Global Catalog — 3269
Terminal services pass-through from PC to iLO 3389 —
iLO Remote Console 17790 —
Virtual media from PC to iLO 17988 —
Remote syslog — 514
You can change LDAP and Remote syslog port numbers.
If a protocol is disabled, then the corresponding ports are also disabled.
To use EDPC, iLO firmware 1.70 or later is required.