HP Onboard Administrator - Manual (Page 219)

Configuring the HP BladeSystem c7000 enclosure and enclosure devices 219
Connection Port Number Connects to interconnect bay/port
B-Side Mezzanine 7 Port 1
Port 2
Port 3
Port 4
3/Port N+3
4/Port N+3
3/Port N+11
4/Port N+11
Device bay port mapping graphical view for c7000 enclosure
Half-height server blade
In this diagram, N equals the number of the server blade in the enclosure and the port number on the switch.
For example, if a server blade is inserted into slot 1, it is considered device 1, and the ports that will be used
in switch 1 and switch 2 are ports 1 and 1, respectively. If a server blade is inserted into slot 2, then the ports
used on switch 1 and switch 2 are ports 2 and 2. This convention changes for the full-height server blades as
seen in the next diagram.
Full-height server blade
In this diagram, N equals the number of the blade in the enclosure and the port number for the switch. For
example, if a blade is inserted into slot 1, it is considered device 1. Because full-height server blades take up