HP Onboard Administrator - Manual (Page 73)

First Time Setup Wizard 73
First Time Setup Wizard IPv4 Network Settings Screen
Either use a DHCP service to assign IP settings to your Onboard Administrators, or manually assign static IP
settings.
First Time Setup Wizard IPv4 Network Settings
Use DHCP for all Active (or Standby) Onboard Administrator—Obtains the IP address for the Onboard
Administrator from a DHCP server. The Standby check box is only shown if there is a Standby Onboard
Administrator in the enclosure.
Enable Dynamic DNS—Enables you to use a host name for the Onboard Administrator. The host name is
registered with a DNS server. DDNS updates the DNS server with new or changed records for IP addresses.
This feature enables you to use the same host name over time, although the dynamically assigned IP address
might change.
Use static IP settings for each Active (or Standby) Onboard Administrator—Manually set up static IP settings
for the Onboard Administrator. The Standby check box is only shown if there is a Standby Onboard
Administrator in the enclosure.
The following table describes other settings available on the screen:
Field Possible value Description
DNS Host Name
1 to 32 characters including all
alphanumeric characters, the
dash (-), and the underscore
(_).
The Onboard Administrator DNS host name.
The DNS host name can be assigned when
using either DHCP or static IP settings.
IP Address ###.###.###.### where ###
ranges from 0 to 255
Static IP address for the Onboard Administrator
(required if static IP settings is selected)