HP Onboard Administrator - Manual (Page 114)

Configuring the HP BladeSystem c7000 enclosure and enclosure devices 114
Forced settings take effect 3 seconds after enabling or disabling the settings. The forced option only
supports NIC speeds of 10Mbps or 100Mb/s.
• NIC Speed—Selects a NIC speed of 10Mb/s or 100Mb/s
To save the new settings, click Apply.
Advanced Settings tab
This screen displays the current enclosure TCP/IP settings (Advanced settings) for the Active Onboard
Administrator. The Advanced Settings tab allows you to enable or disable the DHCP-Supplied Domain Name
option and to input User-Supplied Domain Names for both Active and Standby if the DHCP-Supplied Domain
Name option is disabled. To enable or disable the DHCP-Supplied Domain Name option, or to set
User-Supplied Domain Names, Dynamic DNS must be enabled. To enable Dynamic DNS, use the IPv4
Settings tab (on page
108 ) or the IPv6 Settings tab (on page 110 ).
To override the DHCP-supplied domain name manually, clear the Use DHCP-Supplied Domain Name check
box, and then enter the domain name. Click Apply.
NOTE: When the Use DHCP-Supplied Domain Name check box is selected, you cannot edit the
domain name field.
Network Access