HP Onboard Administrator - Manual (Page 234)

Configuring the HP BladeSystem c7000 enclosure and enclosure devices 234
Row Description
Status The overall status of the storage blade. Possible values are Unknown, OK, Degraded,
and Failed.
Powered The power state of the storage blade. Possible values are On or Off.
Power Allocated The amount of power allocated for use by the storage blade in watts.
Virtual Fan The percentage of maximum RPM of the virtual fan.
Partner Device* Displays the server blade and bay the storage blade is associated with.
*Not shown
Diagnostic Information
Diagnostic information is gathered by polling a device microcontroller (resulting in a degraded status if a
failure has occurred) or is sent by the device microcontroller, without being polled, to report a failure.
Row Description
Device Identification
Data
Information such as model name, part number, serial number, and other information
used to identify the device is checked. This data is also referred to as FRU data. If the
data is not present or not readable by the Onboard Administrator, a device
identification data error displays. Possible values are OK or Error.
Management Processor Status of the storage controller's management interface processor. Possible values are
OK or Error.
Temperature Temperature is above the warning threshold. Possible values are OK or Temperature
Warning.
Overheat Check Temperature is above the danger threshold. Possible values are OK or Critical
temperature threshold reached.
Power Allocation
Request There is insufficient power to adequately power the storage blade. Possible values are
OK or Insufficient enclosure power.
Cooling There is an insufficient number of fans to properly cool this storage blade or the fan
configuration is incorrect. Possible values are OK or Insufficient fans for enclosure
cooling.
Device Location Storage blade bay configuration status. Possible values are OK or Incorrect location for
proper device cooling.
Device Operational Status of the storage blade. Possible values are OK or Error
Device Degraded Device has failed; status was requested by the Onboard Administrator. Possible values
are OK or Error
Disk Tray DVD Drive. Possible values are Disk Tray is OPEN or Disk Tray is CLOSED.
Partner Device Presence The storage blade has a partner server. It must have a server next to it in the proper
configuration. Possible values are OK or No adjacent partner found.
Power Sequence The storage blade must always be powered up first. If a storage blade is inserted next
to a server blade that is already powered up, it will be denied power. The server blade
must be powered down, so that the storage blade will power up, and then the server
blade can be powered up again. Possible values are OK or Potential partner device is
already ON.
Partner Device Link When degraded, two storage blades have been placed next to each other in the
enclosure. Possible values are OK or Inappropriate device in adjacent bay.
Virtual Connect
Configured Possible values are Configured for Virtual Connect or Not configured for Virtual
Connect.
Temperature sensors information