HP Onboard Administrator User Manual
Page 36
HP BladeSystem Insight Display 36
o
Yes—Copy the configured power settings, rack name, and LCD Lockout PIN (if set) from the
Enclosure Settings screen to the detected enclosures.
o
No—Continue configuring the current enclosure only. The Insight Display installation wizard must
run on each detected enclosure. Select this option if each enclosure requires different power
settings.
IMPORTANT:
If your facility uses Static IP addressing for the Onboard Administrator modules,
you must manually enter those IP addresses into the Insight Display for each Insight Display
separately. You can enter those Onboard Administrator module IP addresses before you send the
settings to adjacent enclosures. You can return to the Enclosure Settings menu after the Installation
Wizard completes to change the Onboard Administrator module IP addresses, if necessary.
7.
Move the cursor to Accept, and press the OK button.
The installation wizard displays the Check: Installation and Cables screen.
8.
Verify all components are installed and connected.
9.
To begin checking for configuration and installation errors, select Continue, and press OK. When
Continue is selected, the enclosure UID automatically powers off. If Push Settings = Yes:
o
The enclosure settings are pushed to adjacent enclosures
o
The installation wizards run on each adjacent enclosure
o
The enclosure UID powers off on the adjacent enclosures