HP Onboard Administrator - Manual (Page 314)

Troubleshooting 314
403 The operation cannot be performed while Enclosure Firmware Management is running.
404 Unable to mount ISO or validate version information.
Check URL and validate ISO is available from URL entered.
405 Unable to open firmware log.
406 The blade's firmware has not been discovered.
407 An error occurred while reading the firmware log.
408 Enclosure Firmware Management is not supported by this device type
409 Firmware ISO image is in use, changing url is not allowed.
410 Blade must be powered off before starting Enclosure Firmware Management.
411 Unable to change passwords for any LDAP or HPSIM users.
412 Enclosure Firmware Management is not available. To use this feature, it needs to be unlocked.
413 Enclosure Firmware Management is not supported on the Active OA hardware present.
414 Could not persist firmware management log.
415 When in FIPS MODE ON/DEBUG, the password length must be between 8 and 40 characters.
416 When in FIPS MODE ON/DEBUG, strict passwords must be enabled.
417 Certificate hash algorithm is not supported. See OA syslog for more information.
418 Downgrade is not allowed in FIPS mode ON/DEBUG. Please set FIPS mode to OFF and retry the
operation.
419 Could not persist firmware management log.
427 E-Keying busy.
428 Error getting CLP strings.
431 Enclosure Firmware Management is not ready, please try again in a few minutes.
434 PIN Protection cannot be disabled in FIPS Mode.
435 Cannot restore the factory defaults while in FIPS mode.
437 Bad EBIPAv6 device.
438 An EBIPAv6 configuration error occurred. Extended information is available as a bitcode reason code.
439 Invalid hash algorithm. The hash algorithm must be one of: SHA1, SHA-224, SHA-256, SHA-384, or
SHA-512.
440 You must set a new pin code before unlocking the LCD buttons.
441 The requested operation cannot be completed during a firmware update.
442 This enclosure is incapable of performing a reset on a non-redundant Onboard Administrator.
444 Power cap configuration locked due to active group management.
REMOTE SUPPORT TIER2
445 HP Remote Support receiver temporarily unavailable. Please retry later.