Signing in to the onboard administrator gui – HP Onboard Administrator User Manual
Page 15
Introduction 15
each user account - or use the Administrator local account to individually update all user passwords after
restoring a previously saved enclosure configuration file.
If the enclosure contains redundant Onboard Administrator modules, the remaining Onboard Administrator
updates the new Onboard Administrator with all the settings.
Signing in to the Onboard Administrator GUI
Enter the user name and initial administration password for your Onboard Administrator. The default account
credentials can be found on the tag attached to the Onboard Administrator.
When signing in to the Onboard Administrator, the following issues might occur:
•
You are not entering the information correctly. Passwords are case sensitive.
•
The account information you are entering has not been set up for HP BladeSystem Onboard
Administrator.
•
The user name you are entering has been deleted, disabled, or locked out.
•
The password for the account must be changed.
•
You are attempting to sign in from an IP address that is not valid for the specified account.
•
The password for the Administrator account has been forgotten or lost. To reset the Administrator
password, see "Recovering the Administrator password (on page
)."
If you continue to have issues signing in, contact your administrator.
If you have the same credentials on multiple enclosures, you can use single sign-on to log in to multiple linked
enclosures. Before signing in, select the box next to each of the linked enclosures listed in the table on the
Sign-in page, as shown in the following table. In this scenario, you are attempting to log in to three active
Onboard Administrators on the corresponding selected enclosures, using the supplied user name and
password. Alternatively, to verify and log in to all the linked enclosures, select the box at the top of the check
box column. If the login succeeds, then each of those enclosures is viewed in the same GUI window. The
display order of each enclosure is based on the enclosure link cables. Connect the "down-link" port of the