HP Onboard Administrator - Manual (Page 238)

Configuring the HP BladeSystem c7000 enclosure and enclosure devices 238
Interconnect bays
Interconnect Bay Summary screen
In the Enclosure Information menu, the Interconnect Bays category lists all the interconnect devices within the
enclosure. Selecting the interconnect bays menu item directly opens the interconnect device list with a grid
that shows the status of each interconnect device within the enclosure as well as the UID status, power state,
module type, management URL, and product name. These parameters are described in the table near the end
of this section.
The check box in the first column on the top row toggles all check boxes on or off for all interconnect devices.
This feature is useful if, for example, you want to toggle the UID state for all interconnect devices at the same
time. Otherwise, the first column contains check boxes that can be used to select individual interconnects.
After the appropriate interconnects are selected, you can use the Virtual Power or UID State dropdown menus
(click the corresponding down arrow) to perform the appropriate action.
The Virtual Power menu shown in the following figure enables you to turn an interconnect device on or off.
HP recommends that only one device be turned on or off at a time using this feature.
The UID State menu shown in the following figure is used to set the UID LED on the interconnect device.
Turning on the UID LED assists in locating a specific interconnect device within an enclosure. These LEDs can
be turned on or off one at a time or as groups, depending on the check boxes selected.