Kenwood TS-990S - Manual (Page 108)

5-30
5 ASSISTING YOUR SMOOTH QSO
Index Contents
FM REPEATER OPERATION
To operate the transceiver in repeater mode, set the
transceiver to Split mode for use in FM mode and set the
tone signal to ON.
29.520MHz
88.5Hz
29.520MHz
88.5Hz
29.620MHz
29.620MHz
CONFIGURING THE TONE FREQUENCY
You can change the tone frequency.
[F1] [F7]
[ESC]
1 Press and hold [TONE] (F4) while in FM mode to open
the FM Tone Frequency screen.
2 Press [M/S] (F6) to select either main band or sub
band.
The parameter box for the frequency (FREQ. [Hz]) is
activated.
3 Press [ ] (F2) or [ ] (F3) to select
"TONE".
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to select the tone frequency.
5 Press [ESC] to exit.
Note:
◆ If you press and hold [(RESET)] (F1), the selected tone frequency
reverts to the default (88.5 Hz).
Tone Frequency
67.0 88.5 114.8 151.4 177.3 203.5 250.3
69.3 91.5 118.8 156.7 179.9 206.5 254.1
71.9 94.8 123.0 159.8 183.5 210.7 1750.0
74.4 97.4 127.3 162.2 186.2 218.1
77.0 100.0 131.8 165.5 189.9 225.7
79.7 103.5 136.5 167.9 192.8 229.1
82.5 107.2 141.3 171.3 196.6 233.6
85.4 110.9 146.2 173.8 199.5 241.8