Kenwood TS-990S - Manual (Page 111)

5-33
ASSISTING YOUR SMOOTH QSO 5
Index Contents
CONFIGURING THE CTCSS TONE FREQUENCY
You can configure the desired CTCSS tone frequency.
[F1] [F7]
[ESC] [MULTI/CH]
1 Press and hold [TONE] (F4) to open the FM Tone
Frequency screen.
2 Press [M/S] (F6) to select either main band or sub
band.
Parameter box for frequency (FREQ. [Hz] allows you to edit.
3 Press [ ] (F2) or [ ] (F3) to select
"CTCSS".
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to select the CTCSS tone frequency.
5 Press [ESC] to exit.
Note:
◆ If you press and hold [(RESET)] (F1), the selected CTCSS tone
frequency reverts to the default (88.5 Hz).
CTCSS Tone Frequency (Hz)
67.0 88.5 114.8 151.4 177.3 203.5 250.3
69.3 91.5 118.8 156.7 179.9 206.5 254.1
71.9 94.8 123.0 159.8 183.5 210.7
74.4 97.4 127.3 162.2 186.2 218.1
77.0 100.0 131.8 165.5 189.9 225.7
79.7 103.5 136.5 167.9 192.8 229.1
82.5 107.2 141.3 171.3 196.6 233.6
85.4 110.9 146.2 173.8 199.5 241.8
SELECTING THE CTCSS TONE
Follow the procedure below to change the type of tone
signal after selecting the main band or sub band.
[F1] [F7] [FM/AM/FM-N]
1 Press [FM/AM/FM-N] to enter FM mode.
2 Press [TONE] (F4) to select CTCSS tone.
Each time you press the key, the tone signal display cycles
as follows: CT (CTCSS) > CROSS > deselected; the main
screen display varies as follows: "TONE" > "CT" > "CROSS"
> blank (deselected) > "TONE".
Note:
◆ If the selected band is dedicated for reception ("TX" LED is unlit),
"CT" will be grayed out.
◆ If the "TX" LED and "RX" LED for the sub band turn Off, "TONE",
"CT", and "CROSS" will also be grayed out.