Kenwood TS-990S - Manual (Page 137)

5-59
ASSISTING YOUR SMOOTH QSO 5
Index Contents
disappears, the transceiver does not revert to the receive
mode after the PSK message for that channel is sent.
7 Press [ ] (F1).
8 Press [ESC] to exit.
Note:
◆ select the channel where the PSK message is stored. After you
confirm that a text string (PSK message) has been transferred to
the buffer of a text string, press [F12] of the USB keyboard.
◆ To place the transceiver in the receive mode after the PSK
message for which automatic reception is disabled, press [F12] of
the USB keyboard.
SENDING A TEXT STRING STORED IN PSK MESSAGE
MEMORY
You can transmit messages entered in the PSK message
memory.
[F1] [F7]
[FSK/PSK/REV]
1 Press [FSK/ PSK/ REV] to enter PSK mode.
2 Press [DECODER] (F3) to open the PSK Encode/
Decode screen.
3 Press [MEMORY] (F5) to open the PSK Message
screen.
If [MEMORY] (F5) is unavailable in the function key guide,
press [MORE] (F1). An alternate key guide will appear.
4 Press [CH1] (F3), [CH2] (F4), [CH3] (F5), [CH4] (F6),
[CH5] (F3), [CH6] (F4), [CH7] (F5), or [CH8] (F6) to
select the channel for which the message to be sent
has been stored.
• The PSK message will not automatically be transmitted
from the channel for which automatic transmission of the
PSK message is disabled
• The key guide for [F1] through [F7] are the key guide
for configuration, including [ ] (F1), [MORE]
(F2), [ ] (F3), [ ] (F4), [MSG] (F5),
[AUTO.TX] (F6), and [AUTO.RX] (F7). In this case,
press [MORE] (F2) so that the key guide will alternate
between the key guide for [ ] (F1), [MORE]
(F2), [CH1] (F3), [CH2] (F4), [CH3] (F5), [CH4] (F6),
and key guide for [NEXT] (F7) and the key guide for
[ ] (F1), [MORE] (F2), [CH5] (F3), [CH6] (F4),
[CH7] (F5), [CH8] (F6), and [NEXT] (F7).
• The transceiver enters the receive mode after the PSK
message displayed along with "AUTO RX" on the right side
is sent.
CONFIGURATION FOR PSK ENCODING AND
DECODING
DISPLAYING THE TIME STAMP
You can display the timestamp whenever transmission and
reception alternate. You can display frequency information
as well as the timestamp.
[F1] [F7]
[MENU] [MULTI/CH]
1 Select Group No. 2, "Decoding & Encoding", from the
Menu screen.
2 Access Menu 13, "RTTY/PSK Time Stamp".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [–] (F4) or [+] (F5), or rotate the MULTI/CH
control to select either "Off", "Time Stamp", or "Time
Stamp + Frequency".
The default is "Time Stamp + Frequency".
5 Press [ ] (F1).
6 Press [MENU] to exit.