Kenwood TS-990S - Manual (Page 206)

13 VOICE MESSAGE AND AUDIO FILE
13-4
Index Contents
CLEARING A VOICE MESSAGE
You can clear a recorded voice message.
1 Press a mode key to select SSB, FM, or AM mode.
2 Press [TX MSG] (F2) to open the Voice Message
screen.
3 Press [ ] (F2) or [ ] (F3), or rotate the
MULTI/CH control to select the voice message channel
to be cleared.
If [ ] (F2) and [ ] (F3) are unavailable in
the function key guide, press [MORE] (F1). An alternate key
guide will appear.
4 Press and hold [(DELETE)] (F7) to clear the selected
voice message.
5 Press [ESC] to exit.
CONFIGURING INTERVAL TIME FOR RETRANSMIT
You can configure the interval time to repeatedly play the
voice message.
1 Select Group No. 5, "CW Configurations", from the
Menu screen.
2 Access Menu 15, "CW/Voice Message Retransmit
Interval Time"
3 Press [SELECT] (F4) to enable editing of the
parameter box.
4 Press [–] (F4) or [+] (F5) to select from the range "0 [s]"
to "60 [s]".
The default is "10 [s]".
5 Press [ ] (F1).
6 Press [MENU] to exit.
RECORDING AND PLAYING COMMUNICATION AUDIO
You can record the contents of communications and play
the recorded audio with this transceiver.
You can select an internal or external memory (USB)
to save the recorded audio file. The following recording
functions are available.
MANUAL RECORDING
You can record a maximum of 30 seconds of audio data
per file to internal memory or a maximum of 9 hours of
audio data per file to a USB flash drive.
FULL-TIME RECORDING
A maximum of 30 seconds of the most recent audio is
recorded to a file.
TIMER RECORDING (USB FLASH DRIVE ONLY)
Audio is recorded to a USB flash drive according to
the configured time and conditions. Refer to "CLOCK
DISPLAY AND TIMER" for details on how to perform timer
recording. {page 15-1}
CONFIGURING THE SAVE DESTINATION OF AUDIO
FILE
You can configure the save destination of the recorded
audio files to either internal memory or USB flash drive.
1 Select Group No. 6, "TX/RX Filter & Misc.", from the
Menu screen.
2 Access Menu 01, "Recorded Audio File Storage
Location".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [–] (F4) or [+] (F5) to select an "Internal" (internal
memory) or a "USB" (USB flash drive).
The default is "Internal" (Internal memory).
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ To save on a USB flash drive, insert a USB flash drive into the
(USB-A) connector before recording. {page 12-1}