Kenwood TS-990S - Manual (Page 215)

14-3
VOICE GUIDANCE 14
Index Contents
The following operating data is announced with an
operation in main band.
Screen Status Detail Status Announcement
VFO mode
Simplex mode Frequency
Split mode "Split" + "RX " + Frequency
Memory Channel
mode
Single-band
Memory mode
"Channel" + Number + (S/D/P/
blank) + Frequency
Dual-band Memory
mode
"Split" + "RX " + "Channel"
+ Number + (S/D/P/blank) +
Frequency
Quick Memory
Channel mode
Simplex mode "Quick" + Number + Frequency
Split mode
"Split" + "RX" + "Quick" +
Number + Frequency
Entering
frequency
If no data is entered "Enter"
Entering frequency
halfway through
Number
The digit indicating MHz is
announced as "dot" followed by
the numbers.
Selecting the entry
history
History frequency
To enter the number in the
1st digit of Memory Channel
number, the voice guidance
announces "Enter" + 1st
digit number, and to enter
the number in the 2nd digit,
it announces 1st and 2nd
digit numbers + Frequency or
"blank".
Editing split
frequency
"SPLIT" LED blinks "Split" + "Enter"
Note:
◆ When switching to VFO mode, Memory Channel mode, or Quick
Memory Channel mode while receiving the operating data in SWL
mode, "SWL" is added at the beginning of voice guidance.
The following operating data is announced upon an
operation in sub band.
Screen Status Detail Status Announcement
VFO mode
Simplex mode Frequency
Split mode "Split" + "TX" + Frequency
Memory Channel
mode
Single-band
Memory mode
"Channel" + Number + (S/D/P/
blank) + Frequency
Dual-band Memory
mode
"Split" + "RX" + "Channel" +
Number + (S/ D/ P/ Blank) +
Frequency
Quick Memory
Channel mode
Simplex mode
"Quick" + Number +
Frequency
Split mode
"Split" + "TX" + "Quick" +
Number + Frequency
Entering
frequency
If no data is entered "Enter"
Entering frequency
halfway through
Number
The digit indicating MHz is
announced as "dot" followed
by the numbers.
Selecting the entry
history
History frequency
Editing split
frequency
"SPLIT" LED blinks "Split" + "Enter"
Note:
◆ When switching to VFO mode, Memory Channel mode, or Quick
Memory Channel mode while receiving the operating data in SWL
mode, "SWL" is added at the beginning of voice guidance.
VOICE 1
Announces the frequency, channel number, contents of
various configuration mode, and menu configurations
displayed in the main band and the sub band.
When fine tuning is disabled, the voice guidance
announces the digits above 10 Hz for VFO and Memory
Channel frequencies. When announcing the number in
the MHz digit, "dot" is also announced along with it. When
selecting a channel with no operating data in the memory
scroll, "blank" is announced.
[MENU]
[VOICE](S) [F1] [F7] [VOICE](M) Tuning (M)
[MULTI/CH]
1 Press the PF key to which [VOICE] (M), [VOICE] (S) or
Voice 1 is assigned.
The operating status is announced. During the configuration
on the configuration screen using the main band, the entered
parameter is being announced, and in the normal conditions,
the operating status of the main band is announced.
Note:
◆ Pressing again during the announcement the PF key, to which
"Voice 1" is assigned, stops the announcement.
◆ Announcement stops when the frequency is changed with the
Tuning or MULTI/CH control during the announcement.
◆ Refer to "PF (Programmable Function)" to change the PF key to be
assigned. {page 16-6}
◆ There is no announcement during the scan.