Kenwood TS-990S - Manual (Page 129)

5-51
ASSISTING YOUR SMOOTH QSO 5
Index Contents
SELECTS THE FILE FORMAT AT THE TIME OF SAVING
DATA
You can select whether the file is saved in the html format
or text format.
[F1] [F7]
[FSK/PSK/REV] [ESC]
1 Select Group No. 2, "Decoding & Encoding", from the
Menu screen.
2 Access Menu 12, "RTTY/PSK Log File Format".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "html" or "txt".
• The extension is either ".html" or ".txt".
• The default is "txt".
5 Press [ ] (F1).
6 Press [ESC] to exit.
ADJUSTING THE RTTY THRESHOLD LEVEL OF
PSK DECODING
The background noise on a signal when no RTTY data is
being received may be erroneously recognized as a letter,
causing unnecessary text to be displayed. The threshold
level should be adjusted to reduce or eliminate this
symptom. If there are many erroneous detections due to
noise, increase the threshold level.
[F1] [F7]
[FSK/PSK/REV] [ESC] [MULTI/CH]
1 Press [FSK/ PSK/ REV] to enter PSK mode.
2 Press [DECODER] (F3) to open the PSK Encode/
Decode screen.
3 Press [THLD] (F5) to allow editing of the threshold
level.
• The threshold level configuration below the Waterfall
display can be changed.
• If [THLD] (F5) is unavailable in the function key guide,
press [MORE] (F1). An alternate key guide will appear.
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to adjust the level.
Pressing and holding [(RESET)] (F1) resets the configured
parameter to the default. The default is "10".
5 Press [ ] (F1).
6 Press [ESC] to exit.