Kenwood TS-990S - Manual (Page 184)

10 MEMORY CHANNELS
10-2
Index Contents
The following operating data appear on the Memory
Channel List screen.
Items Description
Channel
The channel code below appears.
00 to 99: Typical Memory Channels
P0 to P9: Program Memory Channels
E0 to E9: Extensive Memory Channels
Type
The Memory Channel type appears.
S: Single-band Memory Channels
D: Dual-band Memory Channels
P: Program Memory Channels
Frequency 1
You can configure operating data such as the frequency
and operating mode to be used in the main band or the
sub band for single-band Memory Channels.
You can configure the frequency and operating mode
to be used as the main band frequency for Dual-band
Memory Channels.
You can configure the start frequency that specifies the
start point of the program and the operating mode for
Program Memory Channels.
Frequency 2
Nothing appears for Single-band Memory Channels.
You can configure the frequency and operating mode
to be used as the sub band frequency for Dual-band
Memory Channels.
You can configure the end frequency that specifies the
end point of the program and the operating mode for
Program Memory Channels.
TX/RX Func.
You can view the operating category of the transceiver
for Dual-band Memory Channels. Nothing appears for
Single-band Memory Channels.
SPLIT: Split Operation
DUAL RX: Dual-band Receive Operation
SPLIT/DUAL: Displayed when receiving with transmit
frequency during split operation (TF watch).
NAME Displays the Memory Channel name.
L.OUT
Displays the lockout status of each Memory Channel.
The channels with check marks are not subject to the
memory scan.
CONFIGURING THE OPERATING DATA TO A MEMORY
CHANNEL
You can configure the operating data to single-band
Memory Channels and dual-band Memory Channels.
[ESC] [MULTI/CH] [MULTI/CH] [F1] [F7] [M.IN]
CONFIGURING THE OPERATING DATA TO A SINGLE-
BAND MEMORY CHANNEL
The main band or sub band frequency and the operating
mode can be configured in Memory Channels.
1 Select the frequency and operating mode to configure
for the selected band.
2 Press [M.IN] (Memory) to open the Memory Channel
List screen.
3 Press [ ] (F2) or [ ] (F3), or rotate the
MULTI/CH control to select the Memory Channel to
configure the operating data.
Select a Memory Channel from the ranges 00 to 99 and E0
to E9.
4 Press [M.IN] (F4) or [M.IN] (Memory) to configure the
operating data.
• The operating data of the band selected with "Frequency
1" is configured for the Memory Channel and the Memory
Channel List screen closes.
• Press [CANCEL] (F1) or [ESC] to close the Memory
Channel List screen without configuring operating data to
a Memory Channel.
Note:
◆ If a Memory Channel with no operating data stored in the selected
band is used, no operating data is configured for the single-band
Memory Channels.