Kenwood TS-990S - Manual (Page 200)

12 ABOUT THE USB FLASH DRIVE
12-2
Index Contents
4 Press [OK] (F4).
Upon execution of Safe Removal of USB Flash Drive, the
USB screen reappears.
5 Press [MENU] to exit.
6 Disconnect the USB flash drive.
Note:
◆ If "Safe Removal of USB Flash Drive" is assigned to a PF key,
pressing the PF key executes the Safe Removal of USB Flash
Drive, and you can safely remove the USB flash drive. {page 16-6}
SAVING A FILE IN USB FLASH DRIVE
The configuration data and audio data made with this
transceiver can be saved in a USB flash drive.
[MULTI/CH]
[ESC] [MENU] [F1] [F7] [USB]
F[USB DRIVE]
1 Insert a USB flash drive to the (USB-A) connector.
" " blinks on the main screen, and " " lights when the
transceiver recognizes the USB flash drive.
2 Press [USB DRIVE] (F) on the Menu screen to open
the USB screen.
3 Select Menu "Save Configuration Data".
4 Press [SELECT] (F4) to start writing the file.
• The message associated with the data writing appears if
no USB flash drive is detected.
• Pressing [CANCEL] (F7) aborts the procedure without
saving the data.
5 Press [OK] (F4) to exit.
PRECAUTION:
◆ Do not remove the USB flash drive while the configuration data file
or the audio data file is being saved in the USB flash drive. Also,
do not shut down the main power switch (I/O). Otherwise, failure in
the safe removal of the USB flash drive may cause damage to the
USB flash drive, the configuration data file, the audio data file and
malfunction of the transceiver.
Note:
◆ An extension of the saved file is ".dat".
◆ Data files will be saved using a file name consisting of the current
date and time ("YYYYMMDD_HHMMSS.dat").
Example:
20130215_102030.da1 (the name of a file saved on February 15,
2013 at 10:20:30)
◆ The path to the saved file will be “KENWOOD/TS-990/SETTINGS/
DATA”.
◆ Prior to store a file in a USB flash drive, be sure the followings.
• The USB flash drive has been formatted with the transceiver.
• The USB flash drive must be inserted in place.
• The USB flash drive must have sufficient memory space available.
• The USB flash drive must not be write protected or the file system
cannot be corrupted.
READING A FILE FROM USB FLASH DRIVE
The configuration data file and the audio data file stored
in a USB flash drive can be read with the transceiver.
The transceiver can read the configuration data after
adding the following configuration data to the readable
configuration data.
• Configuration data for the operation environment
• Configuration data associated with CW message
• Configuration data associated with recording
• The audio data associated with audio message
[MULTI/CH]
[ESC] [MENU] [F1] [F7] [USB]
F[USB DRIVE]