Kenwood TS-990S - Manual (Page 69)

BASIC OPERATIONS 4
4-15
Index Contents
The default is “Off” (K-type) and “On” (E-type).
5 Press [ ] (F1).
6 Press [MENU] to exit.
DIRECTLY ENTERING THE FREQUENCY
If your desired frequency is far from the current frequency,
directly entering the numbers using the numeric keypad is
the fastest method to enter the frequency.
[1.8]∼[50], [GEN1], [GEN2], [ENT], [CLR]
Band Select Keys
[MULTI / CH]
1 Press [ENT].
A series of dashes ("-") appear on the frequency display for
the selected operating band.
2 Press the numeric keys to enter a frequency.
• Pressing the numeric key replaces the dashes with the
entered number, starting with the leftmost digit.
• To enter 1.82 MHz, pressing [0/50], [1/1.8], [8/24], [2/3.5],
and then [ENT] completes the entry. Always enter a
leading “0” for frequencies below 6MHz.
• Pressing [CLR] during the entry aborts the entry, and the
VFO frequency before the entry began reappears.
Note:
◆ The maximum frequency you can enter is 59.99999 MHz for Fine
Tuning, you cannot enter 60 MHz.
◆ Pressing [ENT] while entering a frequency fills the remaining digits
with 0's.
◆ If you enter a value outside the transmit and receive frequency
range, a beep sounds and the entry will be rejected.
◆ If the first entered value is from 0 to 5, that digit will automatically be
set as the 10 MHz digit; entering a first value from 6 to 9 will set that
digit as the 1 MHz digit.
◆ Even if you enter the 10 Hz digit, "0" will not appear.
◆ Entering the frequency deactivates the RIT and XIT. However, the
respective offset frequencies cannot be released.
◆ In any mode other than AM and FM mode and when Fine Tuning
is disabled, the 10 Hz digit will be the least digit that you can enter,
and in AM and FM modes, 100 Hz digit is the least digit you can
enter.
◆ After entering a frequency while in Auto mode, the operating mode
automatically changes. {page 4-11}
DISPLAYING THE HISTORY OF THE FREQUENCY
ENTRIES
A maximum of the last 10 frequencies entered using the
numeric keypad can be stored in the transceiver. To reuse
a frequency you previously entered, that frequency can be
recalled from the last 10 entered frequencies.
1 Press [ENT] to allow you to enter the frequency.
All digits for the frequency are displayed with "-" (dash).
2 Rotate the MULTI/CH to display the histories.
• Stored frequencies along with their log numbers appear.
The most recent frequency along with the earliest log
number appears first.
• Rotate the MULTI/CH control clockwise to increase the log
number and display the older logs in sequence.
3 Press [ENT] to transfer the selected frequency to the
VFO.
Note:
◆ If the frequency was not correctly entered, the entry will not be
stored as a last entered frequency.
◆ If no frequency has been entered, nothing appears as a last
entered frequency.
◆ If you enter a frequency while the auto mode frequency point is
being configured, nothing appears as a last entered frequency.
◆ If you activate the transverter, all frequency logs will be cleared.