Kenwood TS-990S - Manual (Page 38)

2 PANEL DESCRIPTION
2-12
Index Contents
Area Display Description Ref. Page
Displays the RIT or XIT frequency in the range from -9.999 kHz to 9.999 kHz. {page 5-13}
B
The status varies depending on the audio source for the transmit audio selected using the Data
VOX.
OFF: Appears if no source is selected.
"ACC 2" appears when the audio source is the ACC 2 connector.
"USB" appears when the audio source is the USB audio line.
"OPT." appears when the audio source is the SPD I/F.
{page 9-2}
C
PLAY Appears during quick replay of audio that was recorded using normal or constant recording.
{page 13-4}
PAUSE
Appears while quick replay of audio that was recorded using normal or constant recording is
paused.
REC Appears during the normal recording.
Appears during quick replay of audio after recording and while play of the audio is paused. {page 13-6}
TXEQ BB2
Appears followed by the configuration for the TX DSP equalizer.
OFF, HB1, HB2, FP, BB1, BB2, C, U1, U2, U3
{page 9-9}
BB2 RXEQ FLAT
Left: Appears according to the configuration of the main band RX DSP Equalizer.
OFF, HB1, HB2, FP, BB1, BB2, FLAT, U1, U2, U3
Right: Appears according to the configuration for RX DSP Equalizer for the sub band.
OFF, HB1, HB2, FP, BB1, BB2, FLAT, U1, U2, U3
{page 5-6}
Displays the S-meter dedicated to the sub band. {page 4-18}
D
Displays the meter dedicated to the main band.
• The meter can be displayed as either analog or digital.
• Two styles of analog meter can be selected.
{page 4-19}
E
Displays the operating mode in use. Appears in yellow while Auto Mode is active.
Displays the mode name and the sub number (D1, D2 and D3) while in the DATA mode.
{page 4-10}
{page 4-11}
NOTCH
Appears while Manual Notch, for which Normal has been configured for the notch bandwidth, is
active.
{page 6-10}
NOTCH W
Appears while Manual Notch, for which Wide has been configured for the notch bandwidth, is
active.
{page 6-10}
BEF Appears while the Band Elimination Filter is active. {page 6-12}
NOTCH Appears while the Auto Notch Filter is active. {page 6-11}
Displays the selected IF filter. {page 9-8}
1 BC Appears while Beat Canceller 1 (BC1) is active.
{page 6-14}
2 BC Appears while Beat Canceller 2 (BC2) is active.
Appears while the AGC is inactive.
{page 5-4}
Appears while the AGC is in the slow state.
Appears while the AGC is in the fast state.
Appears while the AGC is in the medium speed.
TONE Appears while the tone function is active. {page 5-30}
CT Appears while the CTCSS is active. {page 5-33}
CROSS Appears while Cross Tone is active. {page 5-34}
F
Appears while receiving on the transmit band.
{page 5-1} Displays the transmitting band. (Only one transmit band for the main band and sub band can be
displayed.)
Appears while transmitting on the transmit band.