Kenwood TS-990S - Manual (Page 237)

USEFUL FUNCTIONS 16
16-5
Index Contents
CONFIGURING THE LENGTH OF TIME FOR KEY
LONG PRESS
In this transceiver, with your key press on the front panel,
the transceiver immediately behaves or enters another
state. Also, there are functions and the configuration
screen that cannot be enabled, activated or displayed
without your long key press on the front panel.
In this manual, the operation to activate such functions or
to open the configuration screen is described as "press
and hold". Some operations, such as operation using
the PTT (microphone) switch, are described as "hold
down". {page VII}
You can configure the duration from when you press a key
until the corresponding function is activated or enabled
or until the configuration screen opens. The duration
configured here will be applied to all operations described
as "press and hold" in this manual.
1 Select Group No. 0, "Basic Configurations", from the
Menu screen.
2 Access Menu 12, "Long Press Duration of Panel Keys".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to select the long key press duration.
• The available parameters are from "200 [ms]" to "2000
[ms]" (in steps of 100 [ms]".
• The default is "500".
5 Press [ ] (F1).
6 Press [MENU] to exit.
ADJUSTING THE BEEP VOLUME
The transceiver beeps upon a key press or function
acknowledgement. The transceiver does not beep if "Off"
has been selected in Menu 1-00.
1 Select Group No. 1, "Audio Performance", from the
Menu screen.
2 Access Menu 00, "Beep Volume".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to select the beep volume level.
• The available parameters are "Off" or from "1" to "20" (in
steps of 1).
• The default is "10".
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ You can configure in Menu 7-14, "Audio Output Type (Rear
Connectors)", whether or not the audio emitted by the transceiver
will be mixed to the received audio and transferred via the SANO
and MANO pins of ACC 2, OPTICAL OUT and (USB-B)
connectors.