Kenwood TS-990S - Manual (Page 248)

16 USEFUL FUNCTIONS
16-16
Index Contents
SELECTING THE OUTPUT SIGNAL TYPE OF THE SUB
BAND FOR AN EXTERNAL METER
You can configure the signal type of the sub band to be
transferred to an external meter from the METER terminal.
1 Press [ADV] (F) from the Menu screen to open the
Advanced Menu screen.
2 Access Advanced Menu 01, "Indication Signal Type
(Sub Band)" 'External Meter 2).
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to select the signal format.
The following signal types are used. The default is "ALC".
TX Power
The transmit power level can be transferred.
ALC
The signal level for the ALC circuit can be transferred.
Vd (Drain Voltage)
The drain voltage value of the power amplification (FET) element can
be transferred.
COMP (Compression Level)
Transfers the level of the audio signal emphasis by a speech
processor.
ID (Current)
The drain current of the power amplification (FET) element can be
transferred.
SWR
The SWR can be transferred.
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ The S meter level of the sub band while receiving is transferred,
and the sub band signal can be transferred in the configured signal
type upon transmit using the main band or sub band.
SETTING THE OUTPUT LEVEL OF AN EXTERNAL
METER
The level of signal output can be configured for the main
band and the sub band independently, according to the
ratings of the external meter connected to the METER
terminal.
1 Press [ADV] (F) from the Menu screen to open the
Advanced Menu screen.
2 Access Advanced Menu 02, "Output Level (Main
Band)" (external meter 1), or Advanced Menu 03,
"Output Level (Sub Band)" (external meter 2).
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to select the output level.
Set the level in a range of 1% to 100% (in steps of 1%). The
default is "50% (2.5 V)".
5 Press [ ] (F1).
6 Press [MENU] to exit.