Kenwood TS-990S - Manual (Page 235)

USEFUL FUNCTIONS 16
16-3
Index Contents
TOUCHING THE SCREEN TO SELECT A
FREQUENCY
By touching the bandscope or waterfall on the main
screen with your finger, you can quickly select the receive
frequency or center frequency to be observed.
[F1] [F7]
[MENU] F[ADV]
TOUCHING THE SCREEN
You can select the frequency by touching the main screen.
To avoid any operations due to accidentally touching the
screen, you can disable Touch Screen Tuning.
1 Select Group No. 0, "Basic Configurations", from the
Menu screen.
2 Access Menu 13, "Touchscreen Tuning".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "On".
The default is "On".
5 Press [ ] (F1).
6 Press [MENU] to exit.
CALIBRATING THE TOUCHSCREEN
If you feel the screen is falsely recognizing the frequency
when you touch the screen, you can calibrate the
contact spots of the touchscreen. If falsely recognizing
is prominent as the time goes by, you can adjust the
touchscreen.
1 Press [ADV] (F) from the Menu screen to open the
Advanced Menu screen.
2 Access Menu 27, "Touchscreen Calibration".
3 Touch the "+" marks that appear on the Main screen, in
sequence.
The "+" mark appears in sequence at the four corners
and the center of the main screen. After touching the "+"
marks at the four corners and the center, in sequence, the
Touchscreen Calibration completes and the Advanced Menu
screen reappears.
Note:
◆ Touchscreen Calibration cannot be terminated. Ensure that you
have touched the "+" marks at all four corners and the center of the
main screen.
◆ If Touchscreen Calibration in progress is terminated due to an
unexpected contingency such as electrical power failure, just
recalibrate the screen.