Kenwood TS-990S - Manual (Page 170)

9-2
9 TRANSMIT FUNCTIONS
Index Contents
SELECTING THE AUDIO SOURCE FOR TRANSMISSION
BY DATA SEND
You can transmit the audio sourced from the MIC
connector, ACC 2, (USB-B), or OPTICAL IN
connector when the PF key for which [DATA SEND] was
assigned.
1 Press and hold [DATA/SEL] to open the Modulation
Source screen.
2 Press [ ] (F2) or [ ] (F3) to select
"DATA SEND".
3 Press [ ] (F4) or [ ] (F5) to select the
audio source.
You can select the audio source to be transmitted upon a
press of [DATA SEND].
4 Press [ON/OFF] (F5) to enable the audio source.
The following table shows the default settings.
Status of DATA
Mode
Modulation Source
MIC ACC 2 USB Audio OPTICAL
DATA Off Off On Off Off
DATA 1 to DATA 3 Off Off On Off
5 Press [ESC], or press and hold [DATA/SEL] to exit.
Note:
◆ The audio signal from the selected audio source will be
transmitted by a press of [DATA SEND]. Refer to "CONVENIENT
FUNCTIONS" for the method to assign "DATA SEND" to a PF
key. {page 16-6}
◆ Both USB Audio and ACC 2 cannot be enabled at the same time.
Enabling one disables the other.
VOX (VOICE-OPERATED TRANSMIT)
VOX is a function that allows you to transmit automatically
while you are speaking into a microphone and to revert to
the receive state when you stop speaking. After speaking
into the microphone, pause momentarily to place the
transceiver in the receive state.
Data VOX enables to transmit the data sourced from the
connectors other than the MIC connector.
SWITCHING VOX (VOICE) ON OR OFF
In SSB, FM and AM modes, you can automatically
transmit by simply speaking into the microphone.
1 Press [VOX/SEL] to enable or disable the VOX
function.
The “VOX” LED lights green while the VOX is active.
Note:
◆ To transmit with VOX enabled, the audio from a microphone is
transmitted regardless of the audio source configuration.
◆ If the transceiver cannot automatically receive with VOX enabled,
reduce the VOX gain, increase the distance between the
microphone and speaker or reduce the receive audio volume. Use
headphones if the transceiver still cannot automatically receive.
SELECTING OR DISABLING THE AUDIO SOURCE FOR
DATA VOX
In SSB, FM, or AM mode, the transceiver can
automatically be in the transmit state by entering the
minimum level or greater of the data transmit audio from
the ANI terminal (ACC 2 connector on the rear panel)
or from (USB-A or USB-B), or the OPTICAL IN
connector. This function is called Data VOX.
Follow the procedure below to change the audio source to
be used for Data VOX.
1 Press and hold [DATA/SEL] to open the Modulation
Source screen.
2 Press [D.VOX] (F7) to select the audio source for Data
VOX.
• Each key press cycles the audio source for Data VOX as
follows: Off (no audio source for Data VOX) > ACC 2 > USB
Audio > Optical > Off.
• The default is "Off".
• "Off", "ACC 2", "USB" or "OPT." appears on the right side
of "D.VOX" on upper side of the main screen.
3 Press [ESC], or press and hold [DATA/SEL] to exit.