Kenwood TS-990S - Manual (Page 16)

1-2
1 INSTALLING AND CONNECTING THE TRANSCEIVER
Index Contents
TORQUE ADJUSTMENT FOR TUNING (M) CONTROL
You can change the rotation torque of the Tuning (M)
control as desired by pinching the ring at the back of
the dial, then rotating the dial. Clockwise increases the
rotation torque and counterclockwise decreases it.
Tight Loose
Hold the ring securely, allowing you to rotate the knob.
ACCESSORIES CONNECTIONS (FRONT
PANEL)
HEADPHONES (PHONES)
The PHONES jack accepts 2-conductor (mono) or
3-conductor (stereo) headphones with an impedance of
4Ω to 32Ω (standard is 8Ω) and a 6.3 mm (1/4") diameter
plug.
While the headphones are plugged in, the audio line for
the internal speaker (or an optional external speaker) is
muted and the audio is heard through the headphones.
The following optional headphones can be used with this
transceiver:
• HS-5 (monaural) • HS-6 (monaural)
Note:
◆ Headphones with a higher impedance also have a higher volume
level.
◆ Refer to "BASIC OPERATIONS" for details of configuration for the
mixing balance to the headphones output and the left and right
reverse. {page 4-23}
FRONT PANEL
GND(STBY)
GND(MIC)
NC
8V(10mA max)
MIC
PTT
DOWN
UP
USB Flash Drive and
USB Keyboard (Commercially
available)
Straight Key (Commercially available)
Paddle (Commercially available)
Headphones
(Optional or Commercially available)
Microphone
(Optional or Commercially available)
Microphone Connector
(Viewed from the Front Panel Side)