Kenwood TS-990S - Manual (Page 86)

5-8
5 ASSISTING YOUR SMOOTH QSO
Index Contents
READING RX DSP EQUALIZER DATA FROM A USB
FLASH DRIVE
Read the configuration data for the TX DSP equalizer from
a USB flash drive.
Note:
◆ Refer to "USING USB FLASH DRIVE" for handling details of USB
flash drives. {page 12-1}
[F1] [F7] [RXEQ/SEL]
[MULTI/CH]
[USB]
1 Press and hold [RXEQ/SEL] to open the RX Equalizer
screen.
2 Insert the USB flash drive on which the Receive
DSP Equalizer Data is stored into the (USB-A)
connector.
When the USB flash drive is recognized, " " appears in
the main screen.
3 Press [ ] (F2) or [ ] (F3) to select the
preset to save the RX equalizer data.
4 Press [READ] (F7) to open the File screen.
The Read Configuration Data screen opens. Pressing
[CANCEL] (F7) reverts to the RX Equalizer screen without
selecting the configuration data.
• Also, on pressing [DELETE] (F6), a message prompting
you to confirm the deletion of the file appears. Press
[CANCEL] (F7) instead of [OK] (F4) to exit without starting
the deletion of the configuration data.
• Pressing [NAME] (F5) enables you to rename the
data. {page 12-4} Pressing [OK] (F4) deletes the file.
5 Press [ ] (F2) or [ ] (F3) and select the
RX equalizer data file to be read.
The RX Equalizer data file can also be selected by a rotation
of the MULTI/CH control.
WRITING RX DSP EQUALIZER DATA TO A USB FLASH
DRIVE
You can create and save a number of different data files
for customized DSP equalizer configurations from which
you can select and read your preferred data.
Note:
◆ Refer to "ABOUT THE USB FLASH DRIVE" for handling details of
USB flash drive. {page 12-1}
1 Press and hold [RXEQ/SEL] to open the RX Equalizer
screen.
2 Insert a USB flash drive into the (USB-A) connector
on the front panel.
• Use the USB flash drive which was formatted by this
transceiver and have sufficient free memory area.
• When the USB flash drive is recognized, " " appears in
the main screen.
3 Press [ ] (F2) or [ ] (F3) to select the
equalizer to be stored.
4 Press [SAVE] (F7) to save the RX DSP Equalizer data
to the USB flash drive.
5 Press [OK] (F4).
Remove the USB flash drive only after Safe Removal of USB
Flash Drive is executed. {page 12-1}
Note:
◆ The saved file is named with the year, month, day, hour, minute and
second. The extension ".equ" is applied to the file.
Example: February 15, 2013, 10:20:30AM: 20130215_102030.equ
◆ The name of the storage folder is as follows:
KENWOOD/TS-990/SETTINGS/RX_EQ