Kenwood TS-990S - Manual (Page 87)

5-9
ASSISTING YOUR SMOOTH QSO 5
Index Contents
6 Select [OK] (F4) from the Read Configuration Data
screen.
• The reading of the RX equalizer data file from the USB
flash drive will start. A message notifying you of the
processing appears when the reading starts.
• If you press [CANCEL] (F7), the Read Configuration
Data screen closes and the RX Equalizer screen appears
again without reading the file data.
• A message notifying you of the completion of data reading
appears when the RX equalizer data file has been read
from the USB flash drive.
7 Press [OK] (F4) to end.
• The reading of the RX DSP equalizer data file from the
USB flash drive has been completed.
• Remove the USB flash drive only after Safe Removal of
USB Flash Drive is executed. {page 12-1}
Note:
◆ Even if the type of the RX equalizer data selected at step 3 differs
from the type of the RX equalizer data when it was saved, the RX
equalizer data saved in the USB flash drive overwrites the selected
RX equalizer data.
PREAMP
Preamp automatically switches at 21.5 MHz from a low-
gain type preamp to a sensitivity-prioritized high-gain type
preamp.
Pressing the [P.AMP] (F) key on the submenu located
on the right side of the main screen toggles the preamp.
Each key press toggles this function between active and
inactive. While the preamp is active, "ON" appears on the
lower line of the key guide.
F[P.AMP]
RX MONITOR
Weak signals may be interrupted by the squelch opening
and closing. Also, you may occasionally wish to monitor
the statuses of channels while you are waiting for a
CTCSS tone. In such cases, use the RX monitor function
to open the squelch temporarily.
You can assign the “RX Monitor” (In Menus 0-15 to 0-32)
to a PF key. {page 16-6} While you press down the PF
key to which “RX MONITOR” was assigned, the squelch
opens and you can monitor the receive frequency.
Releasing the PF key deactivates the RX monitor.