Kenwood TS-990S - Manual (Page 128)

5-50
5 ASSISTING YOUR SMOOTH QSO
Index Contents
Note:
◆ If either of the following is the target for decoding you have
selected, "RX: Reselect PSK" appears on the PSK Encode/
Decode screen.
If any mode other than PSK is selected.
If the receive capability for the sub band is disabled when the sub
band is selected.
◆ If the transceiver is in any mode other than PSK mode, "TX:
Reselect PSK" appears in the RTTY Encode/Decode screen.
Press [FSK/PSK/REV].
SAVING THE CONTENTS OF PSK
COMMUNICATION
You can save the contents of the communication
displayed in the PSK Encode/Decode screen in a USB
flash drive.
Note:
◆ Refer to "USING USB FLASH DRIVE" for handling details of a USB
flash drive. {page 12-1}
[F1] [F7]
[FSK/PSK/REV]
1 Press [FSK/ PSK/ REV] to enter PSK mode.
2 Press [DECODER] (F3) to open the PSK Encode/
Decode screen.
3 Insert a USB flash drive onto the (USB-A)
connector.
Use a USB flash drive which was formatted by the
transceiver.
4 Press [SAVE] (F4) to store the contents of QSO.
A message notifying you of the completion of the data saving
appears.
If [SAVE] (F4) is unavailable in the function key guide, press
[MORE] (F1). An alternate key guide will appear.
5 Press [OK] (F4) to end.
Remove the USB flash drive only after Safe Removal of USB
Flash Drive is executed. {page 12-1}
Note:
◆ The file name is given using the numbers and underscores
representing the time and date, and the extension selected in
Menu 2-12, "RTTY/PSK Log File Format", is also added. The data
is displayed in the order of the year, underscore, hour, minute, and
second.
Example:
Example: In the case of 10:20:30, February 15, 2013:
20130215_102030.txt
◆ The name of the storage folder is as follows:
KENWOOD/TS-990/DECODE/PSK