Kenwood TS-990S - Manual (Page 183)

10-1
10 MEMORY CHANNELS
Index Contents
MEMORY CHANNEL
This transceiver has 120 memory channels and operating
data can be configured for each channel.
There are three types of Memory Channels in 120
Memory Channels, and have the channel number from
00 to 99, P0 to P9, and E0 to E9 following the type. The
outline of the Memory Channels is as follows:
• 00 to 99: Typical Memory Channels to which you can
configure frequently used operating data.
• P0 to P9: Program Memory Channels to which you can
configure the frequency range for the programmable
VFO or the program scan.
• E0 to E9: Extensive Memory Channels which you can
use the same as typical Memory Channels.
There are two types of memory modes for typical Memory
Channels and extensive Memory Channels: single-band
Memory Channel mode and dual-band Memory Channel
mode.
• Single-band Memory Channel mode: Mode to which
the information (simplex frequency, etc.) for operation
in either the main band or the sub band are configured.
• Dual-band Memory Channel mode: Mode to which
the operating data for the operation (split frequency,
dual frequencies reception, transmit frequency during
split operation) using the main band and the sub band
simultaneously can be configured.
The following data can be configured in each memory
channel.
Operating Data
Channel
00 to 99 P0 to P9 E0 to E9
RX Frequency Yes
Yes
(Simplex)
Yes
TX Frequency Yes Yes
Receive Mode Yes
Yes
(Simplex)
Yes
Transmit Mode Yes Yes
Operation category of
this transceiver (split
operation or dual-band
reception)
Yes No Yes
Start Frequency No Yes No
End Frequency No Yes No
Tone, CTCSS cross
tone
Yes Yes Yes
Tone Frequency Yes Yes Yes
CTCSS Frequency Yes Yes Yes
Memory Name Yes Yes Yes
Lockout Yes Yes Yes
DISPLAYING THE MEMORY CHANNEL LIST
The memory channel configurations can be displayed
on the Memory Channel List screen. In the Memory
Channel List screen, you can select a channel to
configure the operating data or channel to operate.
You can assign a name to a Memory Channel.
[ESC] [MULTI/CH] [F1] [F7]
You can select a memory channel in the Memory
Channel List screen.
1 Press [M/V] to enter single-band Memory Channel
mode or press and hold [M/V] to enter dual-band
Memory Channel mode.
2 Press [M.LIST] (F7) to open the Memory Channel
List screen.
• The selected Memory Channel is highlighted in white.
During the configuration of a Memory Channel, it is
highlighted in pink.
• Press [EXTEND] (F7) to extend the Memory Channel
screen. Press [EXTEND] (F7) again to revert the screen
area to its original size.
3 Press [ ] (F2) or [ ] (F3), or rotate the
MULTI/CH control to select a Memory Channel.
4 Press [ESC] to exit.
Note:
◆ You can view the Memory Channel List in VFO mode without
pressing or holding [M/V].