Kenwood TS-990S - Manual (Page 185)

MEMORY CHANNELS 10
10-3
Index Contents
CONFIGURING THE OPERATING DATA TO A DUAL-
BAND MEMORY CHANNEL
You can configure operating data such as the frequency,
operating mode and operating status (split frequency,
dual-band receive frequencies, transmit frequency during
the split operation) for use with split operation or dual-
band reception to a Memory Channel.
1 Configure the frequency, operating mode, and
operating status (split operation, dual frequencies
reception, TF watch) to the main band and sub band.
2 Press [M.IN] (Memory) to open the Memory Channel
List screen.
3 Press [ ] (F2) or [ ] (F3), or rotate the
MULTI/CH control to select the Memory Channel (00
to 99 or E0 to E9) to configure the operating data.
4 Press [D-M.IN] (F6) to configure the operating data.
• The operating data is configured for the main band in
Frequency 1, for the sub band in Frequency 2 and the
operating status is configured for TX/RX Func for the
Memory Channels selected at step 3, and then the
Memory Channel List screen closes.
• Press [CANCEL] (F1) or [ESC] to close the Memory
Channel List screen without configuring operating data to
a Memory Channel.
Note:
◆ Operating data cannot be configured for a Dual-band Memory
Channel in the following cases:
◆ When a Memory Channel with no operating data configured in
main band or sub band is used
◆ When the single-band reception is selected during the simplex
operation ("RX" and "TX" in the sub band displays are both grayed
out)
CONFIGURING OPERATING DATA BY DIRECTLY
ENTERING FREQUENCY
You can configure frequency for Memory Channels or
change existing Memory Channel operating data using
the numeric and band select keypad.
This is useful when tuning the frequency to the station with
a fixed frequency.
[1.8]∼[50], [CLR],[ENT]
Numeric and Band-select Keypad
[M.IN] [ESC] [F1] [F7]
1 Press [M/V] to enter single-band Memory Channel
mode or press and hold [M/V] to enter dual-band
Memory Channel mode.
2 Rotate the MULTI/CH control to select the Memory
Channel (00 to 99 or E0 to E9) to configure the
operating data.
3 Press [ENT] to enable the use of numeric keys.
• Press to turn the backlight for the numeric keypad ON.
• Frequency entry mode is activated for the target band and
the numbers in the frequency display are all replaced with
"-" (dash).
• Press the mode key to change the operating mode.
4 Press the numeric keys to enter a frequency.
• Enter the number with the numeric key, and the dashes
are replaced by the entered number from the uppermost
digit. To enter 1.82 MHz, press [0/50], [1/1.8], [8/24], and
[2/3.5] and then press [ENT] to complete the entry.
• Press [CLR] to clear the entered number, and the
frequency entry ends.
5 Press [ENT] to configure the operating data.
The operating data is configured for the Memory Channel
selected at step 2.
Note:
◆ If a frequency is entered directly in a Memory Channel with no
operating data configured, the frequency is configured as the
operating data of the single-band Memory Channel.
◆ To enter main band and sub band frequencies in a dual-band
Memory Channel, press and hold [M>V] to enter the dual-band
Memory Channel mode. Enter the frequency to the main band and