Kenwood TS-990S - Manual (Page 207)

VOICE MESSAGE AND AUDIO FILE 13
13-5
Index Contents
MANUAL RECORDING
You can start or stop recording of the communications
contents to this transceiver with a press of [REC] or
[STOP]. The recording time differs depending on the
destination of the saved audio file.
Internal Memory: A maximum of 30 seconds per file
(300 seconds in total of the recording time for full-time
recording and manual recording)
USB flash drive: A maximum of 9 hours per file
[ MENU ]
[ USB ]
[ REC ]
[ F1] [F7 ] [ STOP ]
1 Press [REC] to start recording.
• "●REC" appears on the main screen and the "REC" LED
lights.
2 Press [STOP] to stop recording.
• "●REC" disappears from the main screen and the "REC"
LED turns Off.
Note:
◆ If the remaining memory size becomes insufficient while saving an
audio file to internal memory, the audio files with the oldest time
stamp will be deleted. You can configure the transceiver so as not
to automatically delete the audio file when the remaining memory
size becomes insufficient. {page 13-10}
◆ The audio file stored in the internal memory can be copied to the
USB flash drive. {page 12-1}
◆ While saving an audio file to a USB flash drive, the recording stops
when a message appears to notify the available USB flash drive
space becomes low.
FULL-TIME RECORDING
Full time recording is the function that allows recording of
the audio (communications contents) for the maximum
of the last 30 seconds. You can audibly listen to the most
recent communication.
[ MENU ]
[ USB ]
[ REC ]
[ F1] [F7 ] [ STOP ] [ PLAY ]
[ AF ](M) [ AF ](S)
CONFIGURING THE MAXIMUM TIME FOR FULL-TIME
RECORDING
1 Select Group No. 6, "TX/RX Filter & Misc.", from the
Menu screen.
2 Access Menu 00, "Playback Time (Full-time
Recording)".
3 Press [SELECT] (F4) to enable editing of the
parameter box.
4 Press [–] (F4) or [+] (F5) to select "Last 10 [s]", "Last
20 [s]" or "Last 30 [s]".
The default is "Last 30 [s]".
5 Press [ ] (F1).
6 Press [MENU] to exit.