Kenwood TS-990S - Manual (Page 60)

4 BASIC OPERATIONS
4-6
Index Contents
4 Press [-] (F4) or [+] (F5) to select "Font 1", "Font 2", or
"Font 3".
The default is "Font 1".
5 Press [ ] (F1).
6 Press [MENU] to exit.
CHANGING THE DIAL COLOR (SUB SCREEN)
You can select the dial color pattern for the sub screen
from two patterns.
1 Select Group No. 0, "Basic Configurations", from the
Menu screen.
2 Access Menu 03, "Dial Color Pattern".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "Type 1" or "Type 2".
The default is "Type 1".
5 Press [ ] (F1).
6 Press [MENU] to exit.
CAPTURING AND SAVING SCREEN IMAGES
You can capture screen images from the main screen
or the sub-screen and save them to a USB flash drive in
PNG (.png) format. {page 16-12}
SELECTING THE DIMMER
Dimmer is a function to change the brightness of the
screen and LED as you wish.
CHANGING BRIGHTNESS
You can change the brightness of the screens and LEDs
using preset dimmer settings (below). For example,
you can adjust the brightness to be brighter for daytime
operation and darker for nighttime operation.
[DIM/SEL] [MULTI/CH]
[ESC]
1 Press [DIM/SEL] to switch the dimmer.
Can be selected from “Dimmer 1” to “Dimmer 4”.
ADJUSTING THE DIMMER LEVEL
You can create four preset dimmer settings for each of
the main display, sub display, and LEDs. You can then use
these preset settings to easily adjust the display and LED
brightness while operating the transceiver.
1 Press and hold [DIM/SEL] to open the Dimmer screen.
2 Press [ ] (F3) or [ ] (F4) to select “Main
Display”, “Sub Display”, or “LED”.
3 Press [-] (F5) or [+] (F6), or rotate the MULTI/CH
control to adjust the brightness.
Available range is from "5" (dark) to "100" (bright).
4 Press [DIMMER] (F2) to switch the dimmer.
Each key press cycles through Dimmer 1 > Dimmer 2 >
Dimmer 3 > Dimmer 4 > Dimmer 1.
5 Repeat steps 2 and 3.
Note:
◆ Pressing and holding [(RESET)] (F1) resets the configurations so
as to revert to the default.
◆ Brightness of the "TIMER" LED and the " " LED are fixed while
the transceiver power ( ) turns OFF. The configured brightness
does not apply.