Kenwood TS-990S - Manual (Page 20)

1-6
1 INSTALLING AND CONNECTING THE TRANSCEIVER
Index Contents
CONNECTION TO THE LINEAR AMPLIFIER
You can connect a linear amplifier to the REMOTE connector.
Prior to activating the linear amplifier, ensure that you have configured the linear amplifier controls. {page 16-31}
10 ms is the response time from when the transceiver changes from receive to transmit to when is actually transmitted.
In operation other than CW Full Break-in, changing the menu configuration extends the response time to 25 ms (45 ms
for SSB, FM and AM modes).
Note:
◆ The TX/RX control method may vary depending on the type of external linear amplifier. Some linear amplifiers may enter TX mode when the
control terminal is switched to the ground line. For such a linear amplifier, allocate pin number 2 in the REMOTE connector to connect to the
GND terminal and pin number 4 to the control terminal of the linear amplifier.
◆ TL-922 have been discontinued and is no longer available.
CONNECTION TO THE TL-922
TL-922
TS-990S
Supplied 7-pin DIN Plug (Use a self-made connection cable using the 7-pin DIN
plug supplied with the transceiver.)
CONTROL RELAY
Activates if “Active High + Relay” or “Active High + Relay & TX Delay
Control” has been configured for Advanced Menus 11, “Linear Amplifier
Control (HF Band)”, and 12, “Linear Amplifier Control (50 MHz Band)”. To
use with TL-922, you need to configure only in Advanced Menu 11.
2
4
1
6 7
3
5
ALC
GND
R
T
REMOTE
CONNECTOR {page 1-10}
(View from the rear panel)