Kenwood TS-990S - Manual (Page 252)

16 USEFUL FUNCTIONS
16-20
Index Contents
CONFIGURING THE I/O SIGNALS FOR THE ACC
2 CONNECTOR
If you connect an external device to the ACC 2 connector
on the rear panel, you can configure the audio signal input
level.
CONFIGURING THE INPUT AUDIO LEVEL
You can configure the audio signal input level from the
ACC 2 connector on the rear panel.
1 Select Group No. 7, "Rear Connectors", from the Menu
screen.
2 Access Menu 06, "ACC 2: Audio Input Level".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) and [+] (F5), or rotate MULTI/CH control
to select the input level from the available range
between "0" and "100".
The default is "50".
5 Press [ ] (F1).
6 Press [MENU] to exit.
CONFIGURING THE OUTPUT AUDIO LEVEL
If you connect an external device to the ACC 2
connector on the rear panel, you can configure the audio
signal output levels of the main band and sub band
independently.
1 Select Group No. 7, "Rear Connectors", from the Menu
screen.
2 Access Menu 10, "ACC 2: Audio Output Level (Main
Band)" or Menu 11, "ACC 2: Audio Output Level (Sub
Band)".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) and [+] (F5), or rotate the MULTI/CH
control to select the audio signal output level for the
main band from the available range between "0" and
"100".
The default is "50".
5 Press [ ] (F1).
6 Press [MENU] to exit.
SELECTING THE AUDIO OUTPUT FORMAT FROM ACC
2 CONNECTOR
You can select the output format of the received audio
sent from the ACC 2 connector on the rear panel. With the
default configuration, the received audio of the main band
is sent from the MANO terminal, and the received audio of
the sub band is sent from the SANO terminal.
1 Select Group No. 7, "Rear Connectors", from the Menu
screen.
2 Access Menu 17, "ACC 2: Audio Output Configuration".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to select "Normal", "Reversed", or "Mixed".
The default is "Normal".
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ Output audios vary depending on the parameter as follows.
Parameter MANO Terminal SANO Terminal
Normal
Received audio of the
main band
Received audio of the sub
band
Reversed
Received audio of the
sub band
Received audio of the main
band
Mixed
Mixed audio of the
receive signals of the
main band and the sub
band
Mixed audio of the receive
signals of the main band
and the sub band