Kenwood TS-990S - Manual (Page 121)

5-43
ASSISTING YOUR SMOOTH QSO 5
Index Contents
CONFIGURING THE NEWLINE CODE
You can configure the newline code used to receive RTTY
signals. If "All" is selected, a new line starts whenever the
newline code is received. If "CR+LF" is selected, a new
line starts only when the CR+LF code is received.
[F1] [F7]
[MENU] [MULTI/CH]
1 Select Group No. 2, "Decoding & Encoding", from the
Menu screen.
2 Access Menu 02, "Newline Code".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [–] (F4) or [+] (F5), or rotate the MULTI/CH
control to select "All" or "CR+LF".
The default is "All".
5 Press [ ] (F1).
6 Press [MENU] to exit.
DIDDLE OPERATION
This function is used to select what code is transmitted
when all characters being entered by the operator,
or transmitted from a message memory, have been
transmitted in RTTY (FSK) mode. You can select to
transmit a space or a letter code (alphabetical letter), or no
letter will be transmitted.
[F1] [F7]
[MENU] [MULTI/CH]
1 Select Group No. 2, "Decoding & Encoding", from the
Menu screen.
2 Access Menu 03, "Diddle".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "Off" (do not send
the character code), "Blank Code” (send a blank code),
or "Letters Code" (send a letter code).
The default is "Blank Code".
5 Press [ ] (F1).
6 Press [MENU] to exit.