Transmit hold after antenna tuning completes, Configuring the stereo headphones output, Transmit hold after antenna tuning completes -23 – Kenwood TS-990S User Manual
Page 77: Configuring the stereo headphones output -23, Output -23
BASIC OPERATIONS 4
4-23
Note:
◆ If Full Break-in for use in CW mode is active, the antenna tuner for
reception can be active regardless of the above configuration.
◆ If the band for transmission and reception during the Split operation
differs, the antenna tuner does not behave regardless of the above
configuration.
TRANSMIT HOLD AFTER ANTENNA TUNING
COMPLETES
You can continue transmitting even after the antenna
tuning completes.
1 Press [ADV.] (F) from the Menu screen to open the
Advanced Menu screen.
2 Access Menu 09, "TX Hold After Antenna Tuning".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "On".
The default is "Off".
5 Press [
] (F1).
6 Press [MENU] to exit.
CONFIGURING THE STEREO HEADPHONES
OUTPUT
CONFIGURING THE MIX BALANCE OF THE STEREO
HEADPHONES OUTPUT
You can adjust the mixing balance of the received audio
between the left and right channels, for operation with
stereo headphones.
1 Select Group No. 1, "Audio Performance", from the
Menu screen.
2 Access Menu 07, "Headphones Mixing Balance".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to configure the mix balance
from the available range "0" to "10".
• The default is "10". The received audio in the main band
and the received audio in the sub band are equally
distributed.
• If "0" has been configured for menu 1-07 "Headphones
Mixing Balance", the received audio in the main band
and the received audio in the sub band are completely
separated for the left and right channels.
• If "Off" has been configured for menu 1-08 "Headphones
Left/Right Reverse", the received audio in the main band
will be allocated to the left channel, and the received audio
in the sub band will be allocated to the right channel.
• Increasing the configured value causes the level of the
audio in one channel mixed with the audio in other channel
to also be increased.
5 Press [
] (F1).
6 Press [MENU] to exit.
Note:
◆ Following the configuration in Menu 1-08, "Headphones Left/Right
Reverse", the channel that mainly emits the received audio of the
main band can be swapped.
SWAPPING THE RIGHT AND LEFT OUTPUT OF THE
HEADPHONES
You can reverse the audio of the PHONES jack left and
right channels.
1 Select Group No. 1, "Audio Performance", from the
Menu screen.
2 Access Menu 08, "Headphones Left/Right Reverse".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "Off" or "On".
Following is the example of configuration when "0" has been
configured for Menu, "Headphone Mixing Balance".
Configuration
Left Channel
Right Channel
Off
Received Audio in the
Main Band
Received Audio in the
Sub Band
On
Received Audio in the
Sub Band
Received Audio in the
Main Band
5 Press [
].
6 Press [MENU] to exit.
Note:
◆ The wiring in the headphones jack plug determines whether the
right channel audio or the left channel audio sounds from the left or
right channels of the headphones.