Controller cover removal, Controller, Cover – INFICON MDC-260 Thin Film Deposition Controller User Manual
Page 105: Removal -5, 1 and sw2. refer to section 8.5 and
MDC-260 DEPOSITION CONTROLLER
CONTROLLER INSTALLATION
8-5
8.5 CONTROLLER COVER REMOVAL
WARNING: Under no circumstances should the controller cover be removed
without first removing the line voltage cord, as dangerous voltages are present
inside the case.
WARNING: The controller contains no user serviceable parts. Only trained
technician should attempt to service it.
CAUTION: To prevent damage to internal components by means of
electrostatic discharge (ESD), wear a grounded anti-static wrist strap.
Five screws located on the top of the unit and 1 screw on the rear panel secures
the cover of the Monitor. Remove the 6 screws, and slide the top cover toward
the rear.
To reinstall the cover, slide it into the groove created by the front and side panels,
then replace the screws.
WARNING: To avoid electrical shock or personal injury, do not operate the
controller without its cover installed in place.