INFICON MDC-260 Thin Film Deposition Controller - Manual (Page 77)

MDC-260 DEPOSITION CONTROLLER
PROGRAMMING AND CONTROLLER SETUP 4-41
This parameter sets the controller’s computer interface address for the USB
interface. This number will be transmitted as a part of all messages sent to and
from the MDC-260 from a host computer.
4. Attention Volume (0-10)
This parameter sets the volume of audio attention sound. Attention sounds
indicate that the controller is waiting for an operator response or action before
continuing the process. A setting of zero disables audio attention sound.
5. Alert Volume (0-10)
This parameter sets the volume of audio alert sound. Alert sounds indicate that a
material alert level has been exceeded. A setting of zero disables audio alert
sounds.
6. Alarm Volume (0-10)
This parameter sets the volume of audio alarm sound. Alarm sounds indicate that
a material alarm level has been exceeded. A setting of zero disables audio alarm
sounds.