Code #12: delete process, Code #13: send process layer, Code #12: delete process -21 – INFICON MDC-260 Thin Film Deposition Controller User Manual
Page 159: Code #13: send process layer -21
MDC-260 DEPOSITION CONTROLLER
COMPUTER INTERFACE 11-21
Response:
• The controller will respond with the normal transmission receipt.
NOTE:
To modify process layers, you must use the following instructions codes:
• Code #12: Delete Process
• Code #14: Insert Process Layer
• Code #15: Replace Process Layer
Code #12: Delete Process
Description:
Instructs the controller to delete Process #N and its associated
layers.
Format/Example:
• To delete Process #4 in the controller, transmit:
Header
Interface
Address
Inst.
Code
Length
(bytes)
Process #N
(one byte)
Checksum
Dec
255 254
1
12 1
4 238
Hex
FF FE
01
0C 01
04 EE
Response:
• The controller will respond with the normal transmission receipt.
Code #13: Send Process Layer
Description:
Instructs the controller to send the process layer parameters for
Process #N, Layer #Y to the host computer. A description of the process layer
parameter list is as follows:
Parameter Name
Length (bytes)
Decimal Pt.
Position
Range
Units
Layer #N Thickness
3
3
0...999900
Å
Layer #N Material #
1
*
1...8
None
Total: 4 Data Bytes per Layer