INFICON MDC-260 Thin Film Deposition Controller - Manual (Page 60)

MDC-260 DEPOSITION CONTROLLER
PROGRAMMING AND CONTROLLER SETUP 4-24
4.3.3 SYSTEM SETUP
Choosing the Edit System Setup option from the Main Menu screen will present
the System Setup Menu options as shown in Figure 4-7. These options allow for
setting up the controller to interface with the vacuum system and are described
below.
Figure 4-7 System Setup Menu Screen
4.3.3.1 EDIT DISPLAY SETUP
Selecting Edit Display Setup will present the Display Setup screen.
Figure 4-8 Display Setup Screen
1. Pause On Layer Complete (Yes or No)
This parameter determines whether the controller will pause between layers. If
this parameter is set to Yes then the controller will stop after completing a layer
and wait for a Start key press from the operator. If this parameter is set to No
then the controller will automatically increment to the next layer.
2. Display Negatives (Enabled or Disabled)
This parameter defines whether the MDC-260 will display negative rates and
thickness or not. If set to disable, the MDC-260 will hold negative values at zero.
The default for this parameter is Disabled.
3. Thickness Graph Scale (2-digit, 3-digit)
This parameter defines whether the rightmost 2 or 3 digits of thickness will be
graphed effectively setting the graph range at either 100 or 1000Å.
4.
Sensor Status (Thickness, Frequency)
System Setup Edit Display Setup
Program Inputs
Program Outputs
Program Actions
Edit Sensor Setup
Edit Source Setup
Edit DAC Setup
Edit Utility Setup
Display Setup
Pause On Layer Complete Yes
Display Negatives Enabled
Thickness Graph Scale 3-digit
Sensor Status Thickness
Time Display Estimated Layer
Rate Graph Disabled
Power Graph Enabled
↓