INFICON MDC-260 Thin Film Deposition Controller - Manual (Page 173)

MDC-260 DEPOSITION CONTROLLER
COMPUTER INTERFACE 11-35
Code #27: Receive Action Setup
Description: Instructs the controller to enter the incoming parameters for Action
#N into memory. Use the table from Code #26 to construct a message to set the
parameters for Action #N to your desired settings.
Format/Example:
• To re-program Action #N with custom parameters, transmit:
Header Interface
Address
Inst.
Code
Length Action #N
(1-8)
25 Data
Bytes
Checksum
Dec 255 254 1 27 26 5 (data) (checksum)
Hex FF FE 01 1B 1A 05 (data) (checksum)
(data): The 25 data bytes represent the configuration parameters the selected
Action.
(checksum):
The checksum from the instruction code through the last data byte.
Response:
• The controller will respond with the normal transmission receipt.